Every corner of the light steel villa should be evenly coated with paint
The thickness of the film is generally 2.5 mm. After the paint is mixed in a ratio of 1:2, it should be fully stirred and painted in 5 times. The amount of each layer should be less than 0.6kg/m2. One night after the fifth step, the scraping operation can be performed. According to the design requirements of the waterproof layer, smooth it with a scraper. The seismic performance of the light steel structure of the villa is far superior to that of the traditional concrete and brick houses. At the same time, due to the light weight of the light steel structure, the weight per unit area is only 1/4 of the weight of the brick-concrete structure of the same area, so its foundation is easy to handle and suitable for most geological conditions. Steel-framed homes no longer worry about termites as much as wood-framed houses. Because the steel used in the structure of the light steel villa company is all factory processed, the structural precision of the light steel structure villa is quite high. The structural system of a villa consists of tens of thousands of components, and the average error of each component is less than 2mm, which ensures the quality of the house. What the conservative construction method cannot achieve is to promote the industrialization of construction, which will contribute to energy conservation and environmental protection, and is of great benefit to the management of the atmosphere. Therefore, the development of light steel buildings has been put on the agenda.
The dosage of the bottom layer after dilution is 0.3KG/㎡. Note that every corner of the light steel villa should be painted evenly. Every corner needs to be brushed several times. After the coating is dry, use a round wooden stick to spread the non-woven fabric (60-80g) for construction. Level the ground for foundation treatment. Smooth the uneven and cracked areas, and perform plugging treatment to make them smooth, firm, clean and free of leakage. Beforehand, the sides, seams and bites at the bottom of the gutter need to be caulked with polyurethane sealant and leveled with paint. Make the edge arc smooth and flat, without water accumulation. In the gutter, the nozzle should also be tightened and the joints should be filled. Note that the water outlet should not be high, otherwise the entire construction operation will be carried out after the water has been treated.
